User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Card Management
Delete A Card (Option 0 – Del)
To delete cards, access the Administration menu:
0-Del, 1-Add
2-Find, 3-Config.
To delete a card
1. Press 0.
The following prompt appears:
I/P NUM XXXXXXXXX
HStmp= XXXXXXXXX
This option allows any card in the database to be deleted.
2. Enter the hotstamp number on the unit keypad to select the card for
deletion. If a hotstamp number has fewer than eight digits, precede the
number with zeros (0).
When a card is found, the hotstamp number, together with the
associated PIN, displays, as follows:
DEL? 0-YES
No: XXXXXX XXXX
3. Press 0 to delete the card.
The following screen momentarily displays.
CARD DELETED
4. If any other key is pressed, the following screen displays:
CARD NOT DELETED
Press # to exit the Administration menu without
deleting the card. Press any other key to return to
the I/P NUM prompt.
Software House 49