User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Card Management InfoProx Entry
5. Press 1 to assign a PIN to the card.
The following prompt appears:
Set PIN XXXX
6. Enter a four-digit PIN.
7. To add the card without a PIN, press any key other than 1 at the PIN
prompt, as in step 4.
Before returning to the I/P NUM prompt, the display will indicate whether
the card system number has been added or if the card system number
already exists in the database.
48 Software House