User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Card Management InfoProx Entry
6. Card Management
Adding Cards (Option 1 - Add)
Card management is accessed through the Administration menu:
0-Del, 1-Add
2-Find, 3-Config.
How to add a card by swiping (Option 0)
1. Press 1 to access the Add Card option.
The following prompt appears:
0-By Swipe
1-By Keypad
This screen allows a card to be added to the database.
Note Each card has a unique encoded number (system
number), which must be added either through the keypad or
by a card being presented to the reader. Unless you know
the embedded system number, presenting the card to the
reader is the best way to enter this number.
2. Press 0 (By Swipe) or 1 (By Keypad).
44 Software House