User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Configuring the Door Control Unit InfoProx Entry
Exit Configuration
The Exit Configuration option is used to configure the door control unit to support
an InfoProx Exit unit and/or DIU (Door Interface Unit Module). You need to setup
this feature only if you are using an exit reader/unit or DIU controlled by the
primary door control unit, an InfoProx Entry.
To setup the exit configuration
1. From the Configure Reader screen, press the # key five times to
continue to the exit configuration prompt.
The following prompt appears:
Ù Alter #Exit
EXIT N DIU N
2. Press Ù to toggle between setup options: NN, NY, YN, YY.
3. Press # to move to the next screen: Relay Idle State.
The following table shows the exit configuration setup sequences.
Display Exit DIU
NN No No
NY No Yes
YN Yes No
YY Yes Yes
42 Software House