User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Configuring the Door Control Unit
Keypad Enable / Disable
This mode enables or disables the keypad. If the cardholder has been allocated a
PIN and the keypad has been disabled the cardholder will not be asked to enter a
PIN when presenting his/her card to the reader.
To enable/disable keypad
1. From the Configure Reader screen, press the # key four times to
continue to the enable/disable keypad prompt.
The following prompt appears
Ù Alter # Exit
Keypad
2. Press Ù to toggle the keypad on or off: Keypad or No Keypad.
3. Press # to confirm the selection and to go to the next screen: Exit
Configuration.
Software House 41