User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Configuring the Door Control Unit InfoProx Entry
Contrast
The first screen in the unit setup sequence is Contrast.
To alter the contrast
1. From the Configure Reader screen, press # twice to continue to the
Contrast screen.
The following prompt appears:
Alter Contrast
1 + 2 -# Exit
2. Press 1 to set a darker display.
3. Press 2 to set a lighter display.
4. Press # to move to the next screen: Door Mode.
Door Mode
Two door modes are available:
· Door Reader: the standard door mode for a reader controlling access
at a door. When the reader is configured as a door reader, three of the
four inputs are reserved for door position, lock status and request to
exit, leaving one spare input.
· Control Post Reader: a door mode used to validate cards, normally at
a manned control point having no physical barrier or door.
To configure the door mode
1. From the Configure Reader screen, press the # key three times to
continue to the door mode prompt.
The following prompt appears:
Ù Alter # Exit
Door Reader
2. Press Ù to change between the door modes.
3. Press # to confirm the selection and move to the next screen.
40 Software House