User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Configuring the Door Control Unit InfoProx Entry
Site Code
The manufacturer for each batch of cards embeds the site code. Usually, the user
requests site codes on a card order form. Batches of cards can also be issued
without site codes. As a rule, the manufacturer will provide this code to
administrators.
The prompt appears after the GIN is entered, viewed, or bypassed on the previous
screen.
Set Scode=XXX
New Scode=XXX
To identify cards used by cardholders, the reader requires a unique site code. If no
site code is entered, any card that is added will be valid and will enable access.
However, if a site code is entered, only those cards with the embedded code will
be valid and will enable access.
Entering a site code
1. Enter the three-digit site code.
A tone confirms that the site code has been accepted.
2. Press # to continue with unit setup or wait for the screen to time out.
You are returned to the first Administration menu.
Any cards entered prior to configuring a site code will
not be valid cards unless they contain the site code.
If no site code is entered or if 0 is entered, the LCD
displays –1, indicating that no site code is being
used.
38 Software House