User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Configuring the Door Control Unit InfoProx Entry
Configuring Free time zone mode
Free mode allows access during the time zone without a card or PIN.
1. On the Config TZ Type menu, press 3.
The following prompt appears
TZ FREE ACCESS
Ù to accept
Free means No Card and No PIN Timezone.
2. Press Ù to accept.
This time zone would be useful in situations where
restricted access to a facility is not necessary during
normal operating hours. After the time zone ends;
however, Normal access with a Card and PIN will be
required.
Configuring Card-only time zone mode
You can gain access during the time zone only with a valid card. “Swipe” in
this context has the same meaning as “present card”. The door control unit
does not have a swipe read head.
1. On the Config TZ Type menu, press 4.
The following prompt appears
TZ=SWIPE ONLY
Ù to accept
This sets the time zone for Card-only access.
2. Press Ù to accept.
After selecting a time zone type and pressing Ù to accept, the Config I/Ps
screen will display.
34 Software House