User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Configuring the Door Control Unit
Configuring Normal time zone mode
This is the default mode, where access requires both a Card and a PIN.
1. Press 1.
The following prompt appears
TZ=Normal Access
Ù to accept
2. Press Ù to accept.
Configuring PIN time zone mode
In this mode, access is granted by using a GIN at the keypad without a card.
1. On the Config TZ Type menu, press 2.
The following prompt appears
TZ PIN ONLY
Ù to accept
This sets a PIN-Only Timezone, as in this example, a GIN.
2. Press Ù to accept.
Note When associated with a Time Zone, PIN refers to the Global
Identification Number (GIN) and not the PIN associated with
a particular card.
Software House 33