User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Configuring the Door Control Unit InfoProx Entry
Time zone types
Once Timezone start and end have been set, you can define an operating mode
by choosing a time zone type. If you don’t want to use time zone types, press # at
any time to bypass individual Timezone Types configuration.
Figure 8 illustrates the most common time zones between a start and end time of
8:00 am (08:00) and 5 pm (17:00).
Figure 8: Common time zone configuration
Because Normal Mode (Card and PIN) is the default mode for the reader, which
is in effect 24 hours, setting up a time zone for Normal mode is only useful for
weekends, holidays, or special situations. For instance, a time zone might be set
to Free or PIN from 08:00 to 17:00 Monday through Friday, but on weekends, the
administrator might set the time zone type to Normal, allowing access only with a
card. You could then set the time zone to Free or PIN on Monday, which allows
the time zone times to stay intact. Then the administrator only has to change time
zone types each week.
Configuring time zone types
1. At the Config TZ Type menu, press 0-Yes.
The following prompt appears.
1 Normal, 2-PIN
3-Free, 4-Swipe
Select one of the four menu choices. These menu items are described
on pages 24 ad 25.
Note This screen will display only if Config Time has been set.
32 Software House