User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Configuring the Door Control Unit
0-Yes Other-No
7. Press 0 to setup time zone types, as in Section 3.7. Press any other
key or # to bypass this mode.
Once a time zone is configured and the time zone period starts, the
amber LED flashes until the time zone period ends. For example, if the
time zone that is setup starts at 08:30 and ends at 17:00, then at 17:01,
the amber LED stops flashing.
To disable a Time zone, reconfigure and set both
times to 00:00.
Example: Time zone allows you to split the day into two sections,
Normal mode (Card plus Pin) and Time Zone mode. Time Zone
mode can be either Free (Door unlocked), Swipe (Card Only),
or Pin (GIN).
Note that the Pin mode does not refer to the Pin associated
with a card, but rather the Global Identification Number (GIN)
that can be used by all personnel once the Time Zone mode is
set to Pin. The three Time Zone modes are less restrictive than
the Normal mode, so the Time Zone is usually set for the day
shift and the non-Time Zone is set for the rest of the 24 hours.
Software House 31