User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Configuring the Door Control Unit
Configure Current Time
Current time is the user’s local time zone and not Greenwich Mean Time (GMT).
Configuring the current time and date
1. On the Config Time screen, press 0 to configure Current Time.
Config Time ?
0-Yes, Other-No
The following prompt appears:
T=HH:MM DD/MM/YY
T=hh:mm dd/mm/yy
2. Enter time in 24-hour format and enter the date as day/month/year.
T=HH:MM DD/MM/YR
T=08:30 15/01/02
Ù to accept
3. Press Ù to accept the displayed time and date.
If Ù is not pressed within approximately five seconds, the unit defaults
back to its default time and date.
Software House 29