User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Configuring the Door Control Unit
Accessing the Administration Menu after Password Setup
After the password has been setup, you can enter the password when the reader
is in standby mode.
Accessing the Administration menu after password setup
1. At the standby screen, enter # 0 Ù then the password.
The first Administration menu appears.
0-Del, 1-Add
2-Find, 3-Config
2. To go to the second menu screen, press Ù.
The second Administration menu appears.
4-Diag, 5-Pword
6-Backup
Software House 25