User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Hardware Installation InfoProx Entry
Installation Checklist
1. Refer to Figure 2, Terminal and Power Connections. Remove the shipping
sticker from the sounder opening.
2. Connect the power source to verify the InfoProx Entry door control unit is
working properly.
3. Recheck the wiring connections; ensure that all terminal screws are securely
tightened.
4. Secure the adapter plate to the containment box (if required for a U.S.
installation).
5. Position the reader over the containment box and tighten the two security
screws, taking care not to over tighten.
6. To prevent light from triggering the tamper sensor, verify that there are no
gaps around the unit.
7. Fit the cover buttons firmly in place over the screws.
To remove the cover buttons, use a screwdriver on the
outer edges to lift the covers.
Once the tamper sensor on the back of the unit is activated,
the reader will sound an alarm when exposed to light.
22 Software House