User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry InfoProx Hardware Installation
Figure 5 illustrates the typical door connection modes.
C NO J2
12345678910
InfoProx Entry
Door State
Monitor (NC)
(Optional)
Lock Status
Switch (NC)
(Optional)
Exit Pushbutton (NO)
Optional
Door
Strike
Door Strike
Power Supply
Figure 6: Typical Connections to a Door
Software House 19