User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry InfoProx Hardware Installation
Figure 4: InfoProx connected to exit reader and PC
Note In some cases, a blue wire will be blue/white and a brown wire will be
brown/white.
Reader Inputs and Outputs
The reader has four analog inputs. For standard door mode, the following applies:
· Input 0 monitors door position (NC)
· Input 1 monitors lock status (NC)
Software House 17