User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Introduction InfoProx Entry
The following table contains the secure and traffic control installation configurations for entry
hardware, exit hardware, DIU, door control wiring, and sounder wiring.
INSTALLATION ENTRY
HARDWARE
EXIT
HARDWARE
DIU DOOR CONTROL
WIRING
SOUNDER
WIRING
Traffic control
(see Figure 2)
Entry reader REX switch No Entry reader Not
applicable
Traffic control
(see Figure 3)
Entry reader Exit reader No Entry reader Not
applicable
Secure (see
Figure 4)
Exit reader Entry reader No Entry reader Exit reader
Secure (see
Figure 5)
Entry reader REX switch Yes DIU DIU
Secure (see
Figure 6)
Entry reader Exit reader Yes DIU DIU
The following diagrams contain the secure and traffic control installation configurations for
entry hardware, exit hardware, DIU, and door control wiring. The diagrams illustrate how to
configure the hardware. For details on connector pins and power wiring, see section 4,
“InfoProx Hardware Installation.” For details on the DIU, see the DIU Installation and
Operation Manual.
8 Software House