User's Manual

Configuring EtherProx Entry EtherProx Entry
To set up an IP Address
1. At the EtherProx keypad, type Ù Ù Ù 0 0 0 0.
The EtherProx Diags menu appears with the following prompt:
<* 0^ 0>
If you do not press a key to select an option on the
Administration menu within 10 seconds, the
Administration menu will disappear.
2. Type # # #.
The following prompt appears on the EtherProx Entry LCD.
Configure
3. Press 0 to select Configure.
The following prompt appears.
IP address
4. Press 0 to select IP address.
The following prompt appears.
Manually
5. Press 0 to select Manually.
The following prompt appears.
Manual IP set
You are now ready to enter the IP address.
6. On the keypad, type the IP address with an asterisk (Ù) to represent a period
(.). Be sure to include a period after the last number in the IP address. For
example, for the IP address 172.31.10.10, type 172Ù31Ù10Ù10Ù
To correct an entry, type a pound sign (#) to cancel
the number. Then retype the IP address number with
the asterisks.
7. When prompted, press # to confirm the new address.
Page 20 Software House