Instruction manual

ManualsBrandsControll-A-Door ManualsGarage Door OpenerS series

Setting Travel Limits

IMPORTANT NOTE: The OPERATE button

will not function until the open and close limit

positions are set.

NOTE: The door and shuttle must be engaged

into the chain index. The door should be open

approximately half way.

Note: If Safety Infra-Red Beam are to be used

they must be installed before setting the travel

limits.

Step 14.1 - Setting Limits Positions

Remove the controls cover to access the controls panel as

shown in (Fig. 22). Replace it when setup is completed.

Step 14.2 - Connect Power to the Drive unit

Plug the power cord into a mains point and switch power

on. The red CLOSE LIMIT LED will be ﬂ ashing.

WARNING: The safety obstruction detection

system is inoperable while MINUS (-) and

PLUS (+) drive buttons are being used and

travel limits are not set.

Step 14.3 - Set the Datum Position

Press and hold the MINUS (-) or PLUS (+) buttons to

move the door to the halfway position. Ensure that the

door, shuttle and chain index are engaged.

Using a small screwdriver, turn the DATUM ADJUST

screw until the STATUS LED comes on (Fig 23).

Note: If the STATUS LED is already illuminated when the

door is halfway up, turn the DATUM ADJUST screw until

the light goes off, then turn back one notch to illuminate

again.

Step 14.4 - Set the Limits Positions

Press and hold the MINUS (-) button until the door

reaches the desired close limit position. Single presses

will inch the door closed (Fig 24).

Press the SET button to store the close position into

memory (Fig. 24).

Press and hold the PLUS (+) button until the door

reaches the desired open limit position. Single presses

will inch the door open (Fig. 24).

WARNING: The door will automatically close,

open and close again once Step 12.4(d) is

performed. Ensure that no persons or objects

are in the door’s path.

Press the SET button to store the open position into

memory (Fig. 24).

The door will now automatically close and open to

calculate the safety obstruction settings. After this, the

opener can be operated with the OPERATE button.

Fig. 24

Fig. 23

Fig. 22

Controll-A-Door

Instruction Manual14