Instruction manual

Thank you for choosing a Controll-A-Door
®
P automatic
garage door opener, designed and developed in Australia
by B&D Doors & Openers.
The technically advanced construction of this B&D opener
ensures you enjoy the following benefits:
Warranty
Five (5) year/10,000 cycles full parts and labour warranty
on motor, electronics and mechanical components of
the opener when installed by an Approved B&D Dealer
(conditions such as annual garage door servicing apply).
Tri-Tran Frequency Hopping Technology
Every time a transmitter is used, it simultaneously sends a
signal over three different frequencies, reducing the chance
of interference from other radio frequency sources.
Code Hopping Technology
Every time a transmitter is used a new security code is
generated from over 4.29 billion possible combinations.
This greatly enhances the security of the system and makes
“code grabbing” a thing of the past!
Multi-Channel Transmitter
Multi-channel transmitters allow you to operate other
devices such as an adjoining garage door or automated
gate from the same handy unit.
Warranty Expired Indicator
The opener will indicate that the number of cycles covered
by the warranty has been reached by flashing the courtesy
light 10 times after each operation. This flashing will
continue for 20 cycles unless it is reset by pressing the
LIMIT SET button while the courtesy light is flashing.
Safety Reversing System
The automatic safety reverse system significantly reduces
the risk of death or serious injury if trapped by a closing door.
The safety reverse force can be adjusted for environmental
conditions such as windy areas.
LED Courtesy Light
Using the latest Light Emitting Diode (LED) technology, the
opener features two light modules consisting of three LEDs
each. These modules produce a brilliant white light that
illuminates the garage upon activation.
The courtesy light automatically switches on for
approximately four (4) minutes (time programmable)
when operating the door. This can also be programmed to
turn on and off from a transmitter.
Memory Retention
In case of a power failure the opener does not lose the
transmitter codes or limit settings.
Manual Release
The manual release handle allows the door to be
operated by hand in the event of a power failure.
Handle needs to be a minimum of 1.8m from floor.
Self Locking
There is no need to manually lock your garage door, as
the opener ‘positively’ locks the door when closed.
Periodic Maintenance Indicator
The SERVICE LED will illuminate to indicate that
periodic maintenance is required. Contact your dealer/
installer for service.
Service Fault Indicator
Flashing LEDs on the control panel easily identify
operational problems or service requirements.
Dynamic Door Profiling
Changing door characteristics are automatically
compensated for and “learnt” with every operation of
the door.
Auto-Close
The Auto-Close option can be programmed to shut the
door approximately 30 seconds after it opens. PLEASE
NOTE - Safety Infra-red Beams must be installed for
this option to function.
External Aerial
An external aerial can be connected for sites where
radio reception is poor.
Vacation Mode
A transmitter can be programmed to disable the
garage door opener’s radio receiver. This is ideal if the
door is to be left idle for prolonged periods.
Pet (Pedestrian) Mode
A transmitter can be programmed to open the door
partially to allow pets access to the garage. The door
opening height is adjustable via a handheld programmer.
Auxiliary Output
You can program a spare button on your transmitter to
operate this output, which can control items that use a
momentary close switching mechanism.
Anti-Travel Electronic Brakes
The opener features an electronic anti-travel brake
mechanism to ensure the opener stops the door
exactly at the set limit positions.
About Your B&D Opener
Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
5Controll-A-Door
®
P Instruction Manual