Instruction manual

Maintenance
Maintenance
The SERVICE LED will indicate the requirement for a
service and/or adjustment. To reset the SERVICE LED
when the door is serviced, reprogram the Door Travel
Limits and the Door Travel Force – on completion of
this programming the SERVICE LED will go out.
Whilst your opener does not require any periodic
maintenance, the door that it is fitted to does. Your
garage door is a large, heavy, moving object and should
be tested regularly to ensure it is in good condition. A
poorly maintained door could cause fatal or serious
injuries or serious damage to property.
To ensure a long and trouble free life for your opener
the following is recommended:
Monthly
Disengage the opener and manually operate
the door: The door must be smooth to operate
by hand. An operating force on the bottom rail
should not exceed 150N (15kg) force.
Each month check that the opener reverses when
the door contacts a 40mm high object placed on
the floor. Refer to Testing the Safety System (Step
16).
NOTE: If the door does not operate smoothly, call your
nearest Approved Dealer.
Yearly
B&D suggests that you contact your nearest Approved
Dealer to perform an annual door service.
•
•
CAUTION: Frequently examine door,
particularly cables, springs and
mountings for signs of wear, damage
or imbalance. Do not use if repair or
adjustment is needed since a fault in
the installation or an incorrectly
balanced door may cause injury.
Adjustments should only be carried
out by experienced persons, as this
function can be dangerous if not
performed under strict safety
procedures.
WARNING! Failure to maintain your
garage door may void the warranty
on your garage door opener.
Warranty Expired Indicator
When the opener reaches the number of cycles
covered by warranty the courtesy light will flash 10
times after each operation to indicate that the warranty
has expired. This flashing will continue for twenty (20)
operations unless the user acknowledges the warranty
expiry indicator and stops the light from flashing. To
stop the courtesy light flashing press the LIMIT SET
button while the light is flashing after an operation.
Date Service by Signature Invoice No. Amount
Service Record
Record any maintenance in the following table to assist in any warranty service.
Controll-A-Door
®
P Instruction Manual28