Instruction manual

How To Use Your Opener
Manual Door Operation
CAUTION: Do not open manual release in the
open position, only use in the closed position.
Operating the manual release while the door
is open, the door may fall rapidly due to weak
or broken springs, or due to being improperly
balanced.
CAUTION! Do not disengage the opener to
manual operation with children/persons or
any objects including motor vehicles within
the doorway.
To disengage the opener from the door (preferably with
the door in the closed position), pull down on the string
handle on an angle towards the door. This will allow you to
manually open or close the door. To re-engage the opener
pull the string handle away from the door.
WARNING! When the opener is manually
disengaged, the door is no longer locked. To
lock the door manually, re-engage the opener
after the door is closed.
Power Failure
When there is a power failure, the opener will be unable to
automatically open or close your garage door. To use your
door whilst there is no power you will need to disengage the
opener and use the door manually – see Manual Operation
above.
Safety Infra-red Beam
A Safety Infra-red Beam Kit (Part No 062734) may be fitted
to this opener.
When this option is fitted, the operation of this device
is such that if an object (i.e. car, child, etc.) blocks the
Safety Infra-red Beam, then the garage door opener
will not close the door automatically.
If the Safety Infra-red Beam is fitted but not operating
correctly, then the door once opened automatically,
will not close automatically. The door may be closed
by reverting to manual operation – see Manual
Operation.
Auto-Close Option
To have the Auto-Close option functional you must also
have a Safety Infra-red Beam (Part No 062734) fitted and
functioning. To enable the Auto-Close function, place the
AUTO-CLS jumper near the terminal block.
•
•
When this option is selected the garage door opener will
attempt to close the door automatically 30 seconds after
opening.
If the Safety Infra-red Beam is interrupted whilst the door is
closing (e.g. by a person walking through the doorway), the
door will reverse to the fully open position.
If the door does not close automatically, you may close the
door using the Manual Operation.
Courtesy Light
The Courtesy Light will illuminate for approximately four (4)
minutes each time the door is operated automatically.
Spare buttons of a multi-channel transmitters can be
programmed to turn the light on and off by remote control.
See Step 17.2 for more information.
Auxiliary Output
This function allows the opener to operate other devices
such as external lights or an alarm system.
To use this function, a spare button of a multi-channel
transmitter must be programmed to operate the Auxiliary
Output feature.
See Step 17.4 for more information.
Vacation Mode
The radio receiver of the garage door opener can be
turned off to all but one transmitter via Vacation Mode.
Whilst in vacation mode the opener will not respond to any
transmitter.
To activate the Vacation Mode facility, see Step 17.3.
NOTE - program only one button to control “Vacation
Mode”. This will reduce the possibility of accidental
activation of this feature.
Pet (Pedestrian) Mode
A transmitter can be programmed to open the door partially
to allow pet access to the garage.
To activate Pet Mode press the transmitter button that
has been programmed for Pet Mode - the door will open
partially.
See Step 17.5 for more information.
Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
25Controll-A-Door
®
P Instruction Manual