Instruction manual

Fig. 43
How To Use Your Opener
For maximum efficiency of your opener, your garage door
must be in good operating condition. An annual service of
your garage door by an Approved Dealer is recommended.
CAUTON -
Activate the opener only when the
door is in full view, free of obstructions and
with the opener properly adjusted. No one
should enter or leave the garage while the
door is in motion. Do not allow children to
play with or near the door.
WARNING!
This opener is a mains voltage
plug-in domestic appliance and there are no
user serviceable parts inside this opener.
Transmitter
To operate the opener, press the programmed
transmitter button until your door begins to move
(usually 2 seconds). Make sure you can see the door
when you use the transmitter.
If you are in a vehicle you should aim the transmitter
through your windscreen (Fig. 43).
Check that the door is fully closed before you drive
away.
If you press the transmitter whilst the door is moving
the door will stop. The next press of the transmitter will
move the door in the opposite direction.
The transmitter may also be programmed to operate the
following features (see Pages 19 to 21 for more details):
turn the courtesy light on and off
to activate the Auxiliary Output,
to put the door into “Pet Mode” where it opens partially
to allow pet access to the garage, and/or
to put the garage door opener into “Vacation Mode”
where it will not respond to any transmitters.
NOTE: Extra transmitters may be purchased at any time.
Removing the Battery From the Transmitter
(Battery Type: 3V Lithium Battery CR2032).
Use a non-metallic object to remove the battery. (Fig. 44)
Inbuilt Locking Facility
DO NOT lock your door when your opener is engaged as it
has inbuilt locking facility. With the opener engaged your
door will be locked whether the power is on or off.
•
•
•
•
•
•
•
•
REPLACE BATTERY WITH CR2032 ONLY
Fig. 44
Controll-A-Door
®
P Instruction Manual24