Instruction manual

Step 17.5 - Setting the Transmitter to Operate Pet

(Pedestrian) Mode

The opener can be programmed into a “Pet Mode” where the

door opens partially to allow pets to enter/exit the garage:

Press the CODE SET button ﬁve times, the CODE SET

LED will illuminate and the courtesy light will ﬂash

quickly (twice per second) to indicate learning mode for

Pet Mode is active.

Choose a transmitter button not already coded into the

receiver. Press this button and the CODE SET LED will

begin to ﬂash.

Press the same transmitter button again. The CODE

SET LED will illuminate for one second and then go out,

and the courtesy light will also switch off. This indicates

the code has been stored. This indicates the code has

been stored (Fig. 37).

Step 17.6 - To Erase Programmed Codes

If the CODE SET button is pressed and held for 6 seconds the

CODE SET LED will blink rapidly for one second to indicate

that all programmed codes have been erased. (Fig. 38)

Step 17.7 - Installation of the Wall Mounted

Transmitter

Mount the transmitter in a convenient location, yet out

of reach of children and at least 1.5m off the ground

(Fig. 39).

Make sure the door is visible from this location.

To set the transmitter codes refer to Step 17.1 on page

19.

Press CODE SET

button ﬁve times

Select one of the

four buttons (not

programmed yet ) you

wish to use to control the

door for pet position

Fig. 37

Fig. 38

Fig. 39

Coding Transmitters

Diamond PD Power Drive : Instruction Manual

21Controll-A-Door

P Instruction Manual