Instruction manual

Step 17.3 - Setting the Transmitter to Operate
Vacation Mode
The opener can be programmed into a “Vacation Mode”
where the opener will not respond to any transmitter except
one preprogrammed unit.
Press CODE SET button three times. The CODE SET
LED will illuminate and the courtesy light will flash
slowly (once every two seconds) to indicate Vacation
learning mode is active. (Fig. 35)
Choose a transmitter button not already coded into the
receiver. Press this button and the CODE SET LED will
begin to flash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go out,
and the courtesy light will also switch off. This indicates
the code has been stored (Fig. 35).
To activate Vacation Mode, close the garage door and
press the coded button transmitter for 5 seconds. The
CODE SET LED will illuminate and beep x 2 to indicate
that the opener is in Vacation Mode.
To exit Vacation Mode press the transmitter button
momentarily until the CODE SET LED turns off and
beeps x 1.
Step 17.4 - Setting the Transmitter to Operate the
Auxiliary Output
It is possible to operate other devices (e.g. alarm systems)
using one of the spare buttons of a multi-channel transmitter
coded into the Auxiliary Output feature.
Press CODE SET button four times. The CODE SET
LED will illuminate and the courtesy light will flash
quickly (twice per second) to indicate that learning
mode for the Auxiliary Output is active.
Choose a transmitter button not already coded into the
receiver. Press this button and the CODE SET LED will
begin to flash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go out,
and the courtesy light will also switch off. This indicates
the code has been stored (Fig. 36).
a.
b.
c.
d.
e.
a.
b.
c.
Press CODE SET
button three times
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the Auxiliary out put
Press CODE SET
button four times
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the Vacation Mode
Fig. 36
Fig. 35
Coding Transmitters
Controll-A-Door
®
P Instruction Manual20