Instruction manual

Attaching the C-Rail
Locate shaft into sprocket
Shaft
Track bracket (x2)
Fig. 07
Fig. 06
MARKER
DOOR
SHUTTLE
IMPORTANT NOTE: Do not power up the
powerhead before assembling to the C-Rail.
Step 1 - Centre the Shuttle
Make sure the shuttle is near the MARKER, which is located
in the centre of C-Rail (Fig. 06).
Step 2 - Connect the Powerhead to the C-Rail
Locate and insert the powerhead’s shaft into the C-Rail’s
sprocket as shown in (Fig. 07).
Step 3 - Secure the C-Rail
Fix the two track brackets as shown in (Fig. 08). Fix with
the four screws supplied in accessory pack.
Fig. 08
Controll-A-Door
®
P Instruction Manual10