Instruction manual

Step 20.3 -Connecting The Base Station To The

Opener

a. Connect WHITE wire from base station to 0V on the

terminal block of the opener

b. Connect RED wire from base station to V+ on the

terminal block of the opener.

c. Connect YELLOW wire from the base station to

EB1,EB2 or EB3 on the terminal block of the opener.

See Fig. 40. Please note the exact position of these

terminals will vary by opener type.

Step 20.4 -Coding The Receiver Into The Base

Station

Base station can only hold one receiver in the memory.

Coding a new receiver will replace the old one from the base

station memory.

a. Power up the opener, the LED on the base station will

light up and remains on constantly Fig. 40.

b. Insert two C-type batteries in the receiver. The LED on

the receiver will also lightup and remains on constantly

Fig. 41.

c. Press and hold CODE push button on the base station.

Keep holding until step.e.

d. While holding CODE push button, press and release

RESET button on the base station. The LED on the

base station will start ﬂ ashing.

e. Press RESET button on the receiver for two (2)

seconds, the LED on the base station will start to ﬂ ash

faster. Pause for two (2) seconds, then press reset

button on the receiver again for two (2) seconds. The

LED on the base station will stop ﬂ ashing.

f. Release the CODE push button from the base station

and wait for the LED’s on the base station and on the

receiver to turn off.

g. The LED on the receiver will now start to blink.

h. put the covers back on the base station and receiver

and secure with the 4x #6 x 25 screws (black)

supplied. (Fig. 42)

Receiver

RESET

LED

Wireless Safety Beams Installation

Fig. 41

Fig. 42

Controll-A-Door

Diamond SDO-2v2 Instruction Manual22