Instruction manual

Maintenance
Maintenance
The SERVICE LED will indicate the requirement for a service
and/or adjustment. To reset the SERVICE LED when the
door is serviced, reprogram the Door Travel Limits and the
Door Travel Force – on completion of this programming the
SERVICE LED will go out.
Whilst your opener does not require any periodic
maintenance, the door that it is fitted to does. Your garage
door is a large, heavy, moving object and should be
tested regularly to ensure it is in good condition. A poorly
maintained door could cause fatal or serious injuries or
serious damage to property.
To ensure a long and trouble free life for your opener the
following is recommended:
Monthly
Disengage the opener and manually operate the door: •
The door must be smooth to operate by hand. An
operating force on the bottom rail should not exceed
150N (15kg) force.
Each month check that the opener reverses when the •
door contacts a 50mm high object placed on the floor
(AS3350). Refer to Testing the Safety System (Step
16).
NOTE: If the door does not operate smoothly, call your
nearest Approved Dealer.
Yearly
B&D suggests that you contact your nearest Approved
Dealer to perform an annual door service.
CAUTION: Frequently examine door,
particularly cables, springs and
mountings for signs of wear, damage
or imbalance. Do not use if repair or
adjustment is needed since a fault in the
installation or an incorrectly balanced
door may cause injury. (AS3350)
Adjustments should only be carried out
by experienced persons, as this function
can be dangerous if not performed
under strict safety procedures.
WARNING! Failure to maintain your
garage door may void the warranty on
your garage door opener.
Warranty Expired Indicator
When the opener reaches the number of cycles
covered by warranty the courtesy light will flash 10
times after each operation to indicate that the warranty
has expired. This flashing will continue for twenty (20)
operations unless the user acknowledges the warranty
expiry indicator and stops the light from flashing. To
stop the courtesy light flashing press the LIMIT SET
button while the light is flashing after an operation.
Date Service by Signature Invoice No. Amount
Service Record
Record any maintenance in the following table to assist in any warranty service.
Diamond PD Power Drive : Instruction Manual
© Copyright 2007 B&D Doors
27Controll-A-Door
®
P Diamond Instruction Manual