Instruction manual

How To Use Your Opener
Safety Infra-red Beam
A Safety Infra-red Beam Kit (Part No 062734) may be
fitted to this opener.
When this option is fitted, the operation of this •
device is such that if an object (i.e. car, child,
etc.) blocks the Safety Infra-red Beam, then
the garage door opener will not close the door
automatically.
If the Safety Infra-red Beam is fitted but not •
operating correctly, then the door once opened
automatically, will not close automatically. The
door may be closed by reverting to manual
operation – see Manual Operation.
Auto-Close Option
To have the Auto-Close option functional you must also
have a Safety Infra-red Beam (Part No 062734) fitted
and functioning. To enable the Auto-Close function,
place the AUTO-CLS jumper near the terminal block.
When this option is selected the garage door opener
will attempt to close the door automatically 30 seconds
after opening.
If the Safety Infra-red Beam is interrupted whilst the
door is closing (e.g. by a person walking through
the doorway), the door will reverse to the fully open
position.
If the door does not close automatically, you may close
the door using the Manual Operation.
Courtesy Light
The Courtesy Light will illuminate for approximately
four (4) minutes each time the door is operated
automatically.
Spare buttons of a multi-channel transmitters can be
programmed to turn the light on and off by remote
control.
See Step 17.2 for more information.
Auxiliary Output
This function allows the opener to operate other
devices such as external lights or an alarm system.
To use this function, a spare button of a multi-channel
transmitter must be programmed to operate the
Auxiliary Output feature.
See Step 17.4 for more information.
Vacation Mode
The radio receiver of the garage door opener can be turned
off to all but one transmitter via Vacation Mode. Whilst
in vacation mode the opener will not respond to any
transmitter.
To activate the Vacation Mode facility, see Step 17.3.
NOTE - program only one button to control “Vacation
Mode”. This will reduce the possibility of accidental
activation of this feature.
Pet (Pedestrian) Mode
A transmitter can be programmed to open the door partially
to allow pet access to the garage.
To activate Pet Mode press the transmitter button that
has been programmed for Pet Mode - the door will open
partially.
See Step 17.5 for more information.
Controll-A-Door
®
P Diamond Instruction Manual26