Instruction manual

PWR
AUX
OSC
COM
I R (0V) I R
BLACK
YELLOW
RED
BLACK
YELLOW
RED
BLACK
RED
BLACK
Fig. 38
Fig. 39
Accessories
30V PWR
P . E
P.E 0V
GND
OPERATE
AUX OUTPUT
Safety Infra-red Beam (Part No 062734)
For ADDITIONAL PROTECTION B&D Doors STRONGLY
recommend the fitting of a Safety Infra-red Beam. In most
countries Safety Infra-red Beams are mandatory on all garage
doors fitted with automatic openers. For a small additional
outlay, B&D recommends that Safety Infra-red Beams be
installed with the automatic opener ensuring additional
safety and peace of mind.
IMPORTANT NOTE - The Safety Infra-red
Beam must be installed and connected before
the travel limits are set - See Step 7.
WARNING: Doors requiring over 400N of force
to move must have Saftey Infra-red Beams
fitted for safety.
Locate the Safety Infra-red Beam in a strategic location within
the doorway. It is recommended that it be positioned
150mm above the floor level •
as close as possible to the door opening •
inside the garage•
Make sure to align the beams correctly. Follow the manual
supplied with the Safety Infra-red Beams. Connect the wires
to the terminal block as per (Fig. 38).
WARNING: When using Auto-Close mode and
Safety Infra-red Beams, the doorway must be
clear of all obstructions and persons at all times.
The location of the beam and manner in which it
is installed might not give safety protection at all
times. Check to make sure that the height of the
beam and type used give maximum protection
possible.
WARNING: Automatic door - The door may
operate unexpectedly, therefore do not allow
anything to stay in the path of the door.
CAUTION! The location of the beam and
manner in which it is installed might not give
safety protection at all times. Check to make
sure that the height of the beam and type used
give maximum protection possible.
Electric Key Switch (Part No 062738)
An electric key switch provides an alternative to using a
transmitter. Each key turn cycles through an open/stop/close
function. The electric key switch is also an external release
mechanism - ideal for garages only one entrance.To connect
the switch to the opener’s terminal block refer to (Fig. 39)
and the Electric Key Switch’s instruction sheet.
Controll-A-Door
®
P Diamond Instruction Manual22