Instruction manual

Coding Transmitters
Press CODE SET
button once
Select one of the four
buttons you wish to use
to control the door
Press CODE SET
button twice
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the courtesy light
Fig. 30
Fig. 31
Step 17.1 - Storing the Transmitter Code
The opener can only operate from transmitters that have
been programmed into its receiver. The receiver needs to
learn the codes of any transmitter that will be used with the
operator. Up to fourteen (14) codes can be stored in the
receiver’s memory.
Ensure that the battery is inserted into the a.
transmitter.
Press the b. CODE SET button and release. The
CODE SET LED will illuminate to indicate the
opener is in Code Learn mode. If a valid code is
not stored within 15 seconds the opener will exit
Code Learn (Fig. 30).
Press the transmitter button (one of four) that you want c.
to control the door. The CODE SET LED will begin to
flash.
Press the same transmitter button again. The CODE d.
SET LED will illuminate for one second and then go
out.
The transmitter is now coded to operate the door - press e.
the button to test.
Step 17.2 - Setting the Transmitter to Operate the
Courtesy Light
Although the courtesy light comes on with each operation of
the opener, it may also be controlled by a transmitter without
operating the door.
Press the a. CODE SET button twice. The CODE SET
LED will illuminate and the courtesy light will turn on to
indicate that the light code learning is active (Fig. 31).
Choose a transmitter button not already coded into the b.
receiver. Press this button and the CODE SET LED will
begin to flash.
Press the same transmitter button again. The CODE c.
SET LED will illuminate for one second and then go
out.
The transmitter is now coded to operate the light - press d.
the button to test.
Controll-A-Door
®
P Diamond Instruction Manual18