Instruction manual

Track
Door
Track
Level
Level
Door
Drilled holes
Structural member
Fig. 16
Fig. 15
Fig. 14
Fig. 13
Mounting on a Track Type Door
Step 5 - Determine Bracket Position
Open the door and find the highest point of travel of a.
the top door panel.
Using a level, transfer this height to the wall above the b.
door (Fig. 13) and mark a line 60mm above it.
Determine the centre point on the wall above and on c.
top of the door. Then draw two (2) lines extending
21.5mm from each side of the centre point.(Fig. 14)
Step 6 - Mounting the Wall Bracket
Centre the bracket over the intersection of these two a.
lines. Mark centres for at least two holes (Fig. 14).
Ensure a solid mounting point is behind •
these holes.
Drill holes into the wall with an appropriate sized bit. b.
Secure bracket to the wall using: c.
IF CONCRETE OR BRICK - 10mm dynabolts.
IF TIMBER - wood screw #20 or equivalent
(minimum 50mm long).
WARNING: Make sure concrete, brick wall
or timber lintels are solid and sound so as to
form a secure mounting platform.
Step 7 - Attach the C-Rail to the Wall Bracket
Attach the C-Rail assembly to the wall bracket with the a.
90mm long clevis pin and secure with the supplied
snap pin (Fig. 15).
Leave the powerhead in its packing box for protection b.
during installation.
Step 8 - Securing the Powerhead to the Ceiling
Raise the powerhead from the packing box and a.
support it in the horizontal position with a step ladder
or support system above the door.
Open the garage door. Rest the opener on the open b.
door and use a scrap piece of wood to bring it to
horizontal level.
Line up the track perpendicular to the wall.c.
Secure the perforated angle (not supplied) to the d.
ceiling above where powerhead’s mounting holes will
be once fully installed. A representative mounting is
shown (Fig. 16).
Connect the powerhead to the ceiling mounted e.
perforated angle with M8x20mm screws and nuts.
Strips should not extend more than 18mm below
centre of powerhead mounting holes (Fig. 16).
For an alternative mounting option, go to Step 12.1
WARNING: The opener must be securely
fastened to structural supports, otherwise
opener failure may ensue causing serious
personal injury and/or property damage.
11mm
Diamond PD Power Drive : Instruction Manual
© Copyright 2007 B&D Doors
13Controll-A-Door
®
P Diamond Instruction Manual