User's Manual
Introduction
Thank you for purchasing the Pakedge
As the central component of your wireless
wireless AC networking. The WX
-
can choose their preferred source of wireless internet
performance of the wireless network.
Each band (either 2.4 GHz or 5
GHz) of the
• Access Point Mode:
This is the typical configu
• WDS Bridge Mode:
This mode is
cannot use an Ethernet cable directly. Let’s say you have a desktop computer in an isolated
portion of an old home and can’t run a cable through the whole house to get internet to that
specific computer.
When you put the
an access point in root access point mode and send it to a client device through an Ethernet
connection.
WX
-
1
Thank you for purchasing the Pakedge
WX-1x 802.11ac Dual Band Access Point.
As the central component of your wireless
network, the WX-1x
provides you with high
-
1x broadcasts on both the 2.4 GHz and 5 GHz
band so that select
can choose their preferred source of wireless internet
, improving the overall stability, reli
performance of the wireless network.
GHz) of the
WX-1x can operate in three modes:
This is the typical configu
ration for most Wi-
Fi networks, as shown below.
This mode is
used to send wireless internet to a hardwired device when you
cannot use an Ethernet cable directly. Let’s say you have a desktop computer in an isolated
portion of an old home and can’t run a cable through the whole house to get internet to that
When you put the
WX-1x
in bridge mode, it can receive a wireless signal from
an access point in root access point mode and send it to a client device through an Ethernet
1
-
O
User Guide Version 1.0
provides you with high
-speed, high-range
band so that select
devices
, improving the overall stability, reli
ability and
Fi networks, as shown below.
used to send wireless internet to a hardwired device when you
cannot use an Ethernet cable directly. Let’s say you have a desktop computer in an isolated
portion of an old home and can’t run a cable through the whole house to get internet to that
in bridge mode, it can receive a wireless signal from
an access point in root access point mode and send it to a client device through an Ethernet