User's Manual

Web Management User Guide
- 23 -
（2）ARP configuration and display page
Figure 38 is the ARP configuration and display page, this page can display all of the
information of the ARP table switch, while users can configure a static ARP entries on this page,
delete ARP entries, and revised the dynamic ARP table entry to a static ARP table entry.
When a user configure a static ARP entry, the need to enter the IP address and MAC
address, MAC address must be a unicast MAC address, and then click Add button.
When a user delete an ARP entry, you can choose to delete an IP-ARP table entry, remove
a segment of the ARP table entry, delete all of the ARP table entry, delete all dynamic ARP table
entries and delete all of the static ARP table entry . For the deletion of an IP-ARP table entries,
or delete a segment of the ARP table entry required to enter in the input box, specify the IP
address or IP network segment. Then click the Delete button
When dynamic ARP table entry was revised to a static ARP table entry, you can choose to
a particular network segment or all of the dynamic ARP table entry was revised to a static ARP
table entry. For the situation to a network segment is required in the input box, enter the
specified network segment. And then click Apply button
Figure 38 the ARP configuration and display page
（3）Host Static Routing configuration page
Figure 39 is the host static route configuration page, the user can through this page to add,
delete static routing switch hosts. By default, the switch is not configured to host a static route,
the user can configure the default route through this page, that is the purpose of address /
subnet prefix is 0.0.0.0 / 0 routing