User's Manual

Web Management User Guide
- 21 -
set successful, it will show in the state to active. If the configuration was successful, SNMP
TRAP functions will take effects ,in the event of link up or link down, the switch will automatically
send a TRAP packet to the target address
Figure 34 theTRAP target configuration page
9、ACL Configuraion
（1）IP Standard ACL configuration page
Figure 35 is the IP standard ACL configuration page, users can through this page to build
ACL standard IP-rule base. user can select a ACL group number (the range between 1-99), in
the group to create one or more rules. In a rule can match only the source IP address field (with
mask)
Figure 35 the IP standard ACL configuration page
Users to configure the rules, the source IP address must be in with a mask, the rule can
match the collection of IP addresses. The address mask is use anti-code , if the rule were to
match the IP address range 192.168.0.0 to 192.168.0.255, then the IP address can be
192.168.0.1, and its mask of 0.0.0.255.
Users to configure the rules, each rule must have a filter mode: allow or deny.
The user to create a rule in the group, the system will automatically give the rule a rule