Technical data

CHALLENGE/Onyx Diagnostic Road Map 2-23
on command from F
+ 13: Address Map Request IBus Command Error
8 IA detected parity error
on command from F
+ 14: Interrupt IBus Command Error 8 IA detected parity error
on command from F
+ 15: Load Address Write FCI Error 9 F detected parity error
on data from FCI
+ 16: Unknown FCI Command Error 9 F detected parity error
on command from FCI
+ 17: Address Map Request Timeout Error 8 IA did not return map
response
+ 18: Address Map Response Data Error 8 F detected parity error
on data from ID
+ 19: PIO F Internal Write IBus Data Error
8 F internal problem
+ 20: IBus Surprise 8 F received unexpected
bus-grant/DMA-response
from IA
+ 21: DMA Write IBus Data Error 8 ID detected parity error
on data from F
+ 22: System FCI Reset
+ 23: Software FCI Reset
+ 24: Master Reset 9 F received a reset request
from FCI
+ 25: F Error FCI Reset 9 F reset FCI due to some error
+ 26: F Chip Reset in Progress
+ 27: Drop PIO Write Mode 8 F unrecoverable error
+ 28: Drop DMA Write Mode 8 F unrecoverable error
+ 29: Fake DMA Read Mode 8 F unrecoverable error
+ IBus Opcode+Address: 0xa54b 8 captures the F operation
which received a parity
error.
+ FCI Error Command: 0x3f 9 captures the FCI command
which had a data parity error
+ VMECC in IO4 slot 5 adapter 2
+ Error Cause Register: 0x1fff
+ 0: VME Bus Error on PIO Write (interrupts)
11 error from VME
+ 1: VME Bus Error on PIO Read (no interrupt), return bad parity data
11 error from VME
+ 2: VME Slave Got Parity Error (no interrupt)
10 detected error on FCI
+ 3: VME Acquisition Timeout by PIO Master (interrupt, set dropmode)
11 error from VME
+ 4: FCIDB Timeout (no interrupt) 10 detected error on FCI
+ 5: FCI PIO Parity Error (interrupt) 10 detected error on FCI
+ 6: Overrun among bit 0,1,3,4,5
+ 7: in Dropmode
+ VME Address Error Register: 0xa0001248
+ Extra VME Bus signal register: 0x19e49
+ AM: 0x9 IACK Read AS DS0 DS1
+ VME-Grant-Level: 1: VME backplane levels
+ S1 in IO4 slot 5 adapter 4
+ S1 Command Status Register: 0xffff
+ 6 : Error in SCSI Data DMA channel 0 6 detected error from SCSI