Technical data

6-12 Interactive Diagnostics Environment (IDE)
There are several commands that run a battery of tests. These commands are:
ipall Invokes tests ip1 through ip8.
tlball Invokes tests tlb1 through tlb9
fpuall Invokes tests fpu1 through fpu14.
cacheall Invokes tests cache1 through cache48.
ip19 Invokes all IP, TLB, FPU and CACHE tests.
cache49 Invokes a short version of cache48.
cstate[0 - 21] Invokes individual cache state tests in cache48.
quickfpu Invokes tests fpu1 through fpu13, skipping fpu14.
quickcache Invokes tests cache1 through cache44, then cache47, skipping cache45,
cache46 and cache48.
quickip19 Invokes all IP, TLB, FPU and CACHE tests except fpu14, cache45, cache46
and cache48.
ipresults Displays the test summaries for ipall.
tlbresults Displays the test summaries for tlball.
fpuresults Displays the test summaries for fpuall or quickfpu.
cacheresults Displays the test summaries for cacheall or quickcache.
ip19results Displays the test summaries for ip19 or quickip19. This command is
automatically invoked at the end of ip19 and quickip19.
Identifying IP19 IDE Test Messages
All IP19 IDE error messages are preceded by a number that identifies the message and
helps isolate the problem. The syntax for the numbers is:
01ccnnn
The numbers are interpreted as follows:
01 - the board id for IP19
cc - a hint for failed component(s):
01 - A chip
02 - D chip
03 - CC chip
04 - Primary cache
05 - Secondary cache
06 - R4400
07 - Primary or secondary cache
08 - TLB
09 - FRU
nnn - the error id