User guide

27
Figure 2-6.
Connect Contact for Self Powered Voltage Source Device
Connect to the Relay Ports
The Media Controller provides one relay port as a subset of
the pluggable terminal block provided.
For most applications, attach one wire to the common
terminal and the other to the normally open terminal.
The relay switches close when the relay is activated.
The Media Controller can support applications that require a
normally closed contact.
Add IR Receiver Capabilities to Remote Locations
To add an IR-controlled receiver from a remote location to
your Media Controller:
1. Place your IR-controlled receiver at the remote
location needed.
2. Run the wires from the remotely located IR-controlled
receivers to the back of the Media Controller.
3. Connect the IR-controlled receiver wires (generally
power, signal, and ground) to one of the Media
Controller IR In connectors (pluggable terminal block
connectors).
12V SIG GND
Signal
Input
Return
Path