User guide
System User Guide
Copyright © 2014 Control4. All Rights Reserved.
Saved: 10/28/2013 12:48:00 PM
200-00001 Control4 System
User Guide
Page 145 of 160
Main Option
2nd Option
3rd Option
Description/Action
Config
Display Brightness, Keypad
Brightness, Motion Detect,
Battery Level
Select to change
configurations.
About
View firmware version, date,
and time.
For more information, see the System Remote Control SR-250 User Guide.
6.4 Using Anywhere Access: Web
Use MyControl4 to log into, view, and change your Control4 system using Anywhere Access: Web
Anywhere Access: Web is supported on OS 2.5.0 or later.
This service requires a 4Sight subscription and a MyControl4 account (consumers).
To view your system and use Access Anywhere: Web:
1. Open an Internet browser, and go to customer.control4.com.
2. At Login, log in using the email address and password you and your dealer set up, and then click
Login.
3. In My House, click Connect Now.
OS 2.0 or earlier. If you are connecting to a controller that is running OS 2.0.0 or earlier, an
HTML view displays.
OS 2.0 to OS 2.4.0. If you are connecting to a controller that is running later than OS 2.0.0
but earlier than OS 2.5.0, the Flash view displays by default. You can also connect to the
HTML view if desired.
OS 2.5.0 or later. If you are connecting to a controller that is running OS 2.5.0 or later, the
Flash view displays. The HTML view is not supported.
If you only have one controller, Anywhere Access: Web displays either the HTML view or
Flash view, depending on which software version you have.
If you have more than one controller, you will see a list of controllers. Select the controller you
want to access (see the next figure).