User guide

System User Guide
Copyright © 2014 Control4. All Rights Reserved.
Saved: 10/28/2013 12:48:00 PM
200-00001 Control4 System
User Guide
Page 132 of 160
To connect to a Director:
1. Select the Director to which you want to connect.
2. Select Connect or select Other.
3. If you selected Other, do the following:
a. Select the Name: box. When the on-screen keyboard appears, type the Director name, and
then select Done.
b. Select the IP Address box. When the on-screen keyboard appears, type the Director IP
address, and then select Done.
c. (Optional) Select Cancel to cancel the change and return to the previous screen.
To remove a Director from the list (if you have more than one):
Important: If you remove a Director that the Navigator is currently connected to, the Navigator will
disconnect too.
1. Select the Director to which you want to remove.
2. Select Remove Director.
3. Select the Director to remove.
4. Select Yes.