User's Guide

ManualsBrandsControl4 ManualsElectronicsWireless Keypad Model KPZ-6B1

Control4 Wireless 6-Button Keypad Installation and User Guide 2

Connect the 6-

button keypad wires

to the wall box

wires using wire

nuts. The wall box

wires can differ

depending upon how

it was wired by your

electrician.

To wire the 6-button

keypad for a Control4

single-switch

environment with the

power coming from a

nearby power outlet

or light switch,

connect and cap with

a wire nut the wires

indicated in the table.

Fit wires back into the wall box. Bend the

wires in a zigzag pattern so that they easily

fold into the wall box. Push the 6-button

keypad into place. Adjust the 6-button

keypad so that it is perpendicular to the

floor. Tighten the two screws that hold it in

position in the wall box.

Align 6-button keypad to wall

box and fasten with screws,

unless you are using a Decora

screw-on-style wall plate. If

you are using a screw-on-style

wall plate, before fastening with

screws, you must first align the

wall plate with the 6-button

keypad and the wall box.

If you are using

the Control4

snap-on- style

wall plate, snap it

over the 6-button

keypad now.

Turn ON power at

circuit breaker or

replace fuse from

fuse box.

Test the see if it is working properly.

To operate and configure this 6-button keypad as a stand-

alone device, refer to the documentation that shipped with

your Control4 controller. Refer to information on configuring

or setting up lighting.

Troubleshooting

If light does not turn on:

• Ensure light bulb is not burned out.

• Ensure light bulb is screwed in tightly.

• Ensure circuit breaker is not turned OFF or tripped.

• Check for proper wiring.

Multi-Unit Installations

Multi-unit installations allow you to install

one stand-alone 6-button keypad next to

another in the same wall box. Multi-unit

keypads ship pre-connected. DO NOT

remove side tabs from outer sides.They

help to regulate the capacity.

• With both sides intact (single unit), the capacity is 1000W maximum.

• If you remove one side, the capacity is reduced to 800W maximum.

• If you remove two sides, the capacity is reduced to 600W maximum.

Included Accessories

• Wall Plate

• J-Box Bolts

• Plate Bolts

• A/V/C Keycap Kit

Optional Accessories

• Audio Keycaps

• Video Keycaps

• System Keycaps

Wires from 6-Button Keypad Power Outlet or Light Switch

White (neutral) White (neutral)

Black (hot) Black (hot)

Green (ground) Green (ground)