User's Manual

Intercom (nested under the touch screen) properties:

• Appearance—Select to hide the touch screen from

appearing in Navigators as an available device.

• Behavior—Select the modes you want this touch screen to

support.

• Audio Control—Select the volume of individual audio

settings.

• Sip Information—Information for integrating the touch

screen into your SIP/VoIP system.

• Custom Buttons—Select to enable and label the two

available custom buttons.

• Alternate Camera—Select to use an external camera for

the video associated with the touch screen, for example, a

security camera mounted to the side of the entrance and

pointing at the door.

Mounting options

Place the charging station on any level surface. Consider the

angle of the touch screen’s camera and the position of the people

who will use it while it’s on the charging station.

Portable

You can set the touch screen onto the charging station for

recharging and tabletop use, and lift the screen from the

charging station for portable use. For this option, make sure the

data connection is WiFi (see “Power and network installation

options” above).

Tabletop only

For security purposes, you can permanently attach the charging

station to the touch screen. For this option, we recommend using

Ethernet or PoE for the data connection.

To permanently attach the charging station:

1 Disconnect any cables from the charging station.

2 While holding the charging station upside-down, insert the

mounting screw (included) through the mounting base and

up through the mounting hole in the top.

3 Align the screw with the screw hole in the back of the touch

screen, then tighten to secure it in place.

Permanent mount screw hole