User's Manual

screensaver.ToforcethedeviceintoSleepmode,
pressandreleasethePowerbutton.
Configure the Network Settings
Youmustcongurethenetworksettingsonthis
TouchScreensoitcancommunicatewiththeother
devicesintheControl4system.
Tocongurethenetworksettingsforthisdevice:
1 Ifusingawirelessnetwork,ensurethattheWiFi
WAPisonthesamenetworkastheControl4
Controller.
2 Gatherthefollowingwirelessnetwork
informationfromyourWAP:
• SSID(ServiceSetIdentier).
• WEP/WPA/WPA2securitykey,ifenabled.
• IPAddressingRequirements:ThedefaultisDHCP
(withdynamicaddresses).Ifyouneedtouse
astaticIPaddressinstead,youmustprovidea
networkIPaddressforthisdevice.
3 OntheTouchScreen,tapMore>Settings>
Network.Ifyouwanttousewireless,under
Wireless,selectEnable;otherwise,skiptoStep4.
Followthesestepstocongureawirelesssetup:
a Ifyoudon’tseethenetworkyouwant,select
Other.
b AtNetworkName,selecttoaddtheSSID
ornameofthewirelessnetworkwhenthe
keyboardappears.
c AtSecurity,selectNone,WEP,orWPA.
d AtPassword,typethepasswordgivento
youbythepersonwhosetupthecustomer’s
wirelessnetwork(Control4Dealer).
e SelectConnect.NoticethattheIPsettings
change.
4 TheIPaddressissettoDHCPbydefault.Ifyou
needtosetastaticIPaddressinstead,complete
thefollowingsteps;otherwise,youarenished
withthesesteps.
a OntheNetworkpage,tapStatic (see Figure
8).
dock.
2 InserttheTouchScreenintoitsdock.
3 TurntheTouchScreenanddockupsidedown
andinsertthetwo(2)screws(included).
4 ScrewthedocktotheTouchScreen(Figure7).
Figure7.BottomViewwithDock
5 WakeuptheTouchScreenbyeithertouchingthe
screenorbypressinganybutton.
6 (Optional)YoucanpermanentlymounttheTouch
Screenanddocktoatabletopbyscrewingthe
baseontoaatsurface(screwsnotincluded).
SeeFigure7.
Touch Screen Modes
TheTouchScreenusesthefollowingmodes:
• O:Thescreen,theACPowerindicator,andthe
batteryindicatorarealldark(theTouchScreen
hasnopower).Topowerupthedevice,ensure
thatthebatteryischarged,orthedock’spower
cordisconnectedtothedockandtheTouch
Screenisproperlyseatedinthedock.
• Suspend:Thescreenisdark.butthePower
indicatorislit.Towakeupthedevice,pressany
buttonortaptheTouchScreen.
• Screensaver:Thescreensaverisrunning.Towake
upthedevice,tapthescreen.
• Wake:Thescreendisplaysanythingotherthana
Screw Holes to attach
Touch Screen to Dock
Touch Screen
Dock
Screw Holes for
Permanent Mount
4