User's Manual

34 35
Setup and testing
Function Button Sequence
Identify 4
ZigBee Channel 7
Reboot 15
Factory Reset* 9-4-9
Leave Mesh and Reset* 13-4-13
* The thermostat’s HVAC and Indoor Air Quality
system settings will not be reset.
Managing the ZigBee network connection
The thermostat utilizes special button
tap sequences for managing the ZigBee
network connection. The button tap
sequences are defined in the table.
Button tap sequences that require a
single (1) button should use the
button on the top right of the thermostat.
Button tap sequences requiring two (2)
buttons should use the button and
the button on the bottom right
of the thermostat.
System Test menu
The System Test menu is used to
test a system after installation. The
outputs of the thermostat can be
manually activated to test their
function. The instructions below show
how to enter the test mode and turn
outputs on and o.
To use the System Test menu:
Press button to set the system
to o.
Press and hold button to enter
Installer Mode.
Press or buttons to select TEST.
Press button (Next) to enter
Installer Test. The first screen of the
installer test displays the equipment
configuration.
Press button (Next) to enter the
first installation test or button
(Cancel) to exit.
System Test steps:
Heating equipment test
Cooling equipment test
Fan equipment test
Humidification equipment test
Dehumidification equipment test
Ventilation equipment test
Temperature
Single-button tap
sequences
Two-button tap
sequences
Equipment
configuration