User's Manual

18 19

Setup and testing

Equipment Type

selection switch

This thermostat has the

option of being used in heat

pump or heat/cool systems.

Use the Equipment Type

selection switch on the back

of the thermostat housing to

select this option. This setting

is displayed in the thermostat’s

Installer System Settings menu

under Equipment Type.

Note: The thermostat

reboots within 10

seconds after the

switch position is

changed.

Installer Setup menu

To enter the Installer Setup menu and select equipment to set up:

In the Installer Setup menu, you can select HVAC or Indoor Air Quality Setup.

If Indoor Air Quality Setup is selected, you can then set up Air Cleaning,

Humidiﬁcation, Dehumidiﬁcation, or Ventilation.

Press button to set system to

OFF.

Press and hold

button to enter

Installer Mode.

Press

or buttons to select SETUP.

Press button (Next) to enter

Installer Setup.

Press or buttons to change the

menu selections.

Press button (Next) to accept the

menu selection.

Note:

Select HC (Heat Cool)

or HP (Heat Pump).