User's Manual

6 7
Installation
Thermostat mounting
1 Remove the rear mounting plate
from the thermostat.
2 Pull wires through the opening
on the back of the thermostat.
3 Position and level the mounting
plate of the thermostat on
the wall, and mark the hole
locations with a pencil.
4 Drill 1/4" (6.35 mm) holes and
insert the supplied anchors
(drywall only).
5 Place the mounting plate over
the anchors, then insert and
tighten the screws.
6 Seal the wire entry holes
to prevent drafts aecting
temperature readings.
Wiring terminal
Wire specifications:
18-24 gauge thermostat wire
Installation notes:
• Ensure that power at the
HVAC equipment is o.
• Loosen screw terminals,
insert stripped wire, and
re-tighten.
• Push the excess wire back
into the opening and
plug the wall opening to
prevent drafts.
Y2I1 W2
S2S1
T1 T2 I2
G
Y
O/B
W
RC
RL
C
G
Y
O/B
W
RC
RL
C
Y2I1 W2
S2S1
T1 T2 I2