User's Manual

This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de
brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
IMPORTANT! Tous les changements ou modifications pas expressément approuvés par la partie
responsable de la conformité ont pu vider l’autorité de l’utilisateur pour actionner cet équipement.
Compliance of this equipment is confirmed by the following label that is placed on the equipment:
FCC Part 15, Subpart C / RSS-210 Intentional Emissions Interference Statement
Compliance of this equipment is confirmed by the following certification numbers that are placed on the
equipment:
Notice: The term “FCC ID:” and “IC” before the certification number signifies that FCC and Industry
Canada technical specifications were met.
FCC ID: R33C4SR150Z
IC: 7848A-C4SR150B
This equipment must be installed by qualified professionals or contractors in accordance with FCC Part
15.203 & IC RSS-210, Antenna Requirements. Do not use any antenna other than the one provided with
the unit.
RF Radiation Exposure Statement
This equipment complies with the FCC/IC radiation exposure limits set fourth for portable transmitting
devices operation in an uncontrolled environment. End users must follow the specific operating
instructions to satisfy RF exposure compliance.
 The equipment should only be used or installed at locations where there is normally at least a
20cm separation between the antenna and all persons.
 This transmitter must not be co-located or operation in conjunction with any other antenna or
transmitter.
 Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.