User's Manual

™
©2013 Control4. All rights reserved. Control4, the Control4 logo, the Control4 iQ logo and the Control4 certified logo are registered trademarks or trademarks of Control4 Corporation in
the United States and/or other countries. All other names and brands may be claimed as the property of their respective owners.
control4.com |
Figure 4. Sensor Bar with Split Up/Down Buttons
6 Snap the actuator bar over the thin black rail that
protrudes near the top of the keypad button area
(Figure 5). Orient the actuator bar so that the curved
edge faces toward the top of the keypad and the
bottom straight edge faces toward the bottom of the
keypad.
NOTE: The actuator bar for Keypad Dimmers has
a prong that must be inserted into the Keypad
Dimmer prior to attaching the actuator bar.
Figure 5. Attach Actuator Bar
7 Starting at the top, snap the buttons onto the
keypad in the desired button layout (Figure 6).
Buttons should be oriented so that the status
LED light pipe is on the right side of the button.
Figure 6. Attach All Buttons
Keypad Button Removal
To remove the keypad buttons:
1 If the faceplate is already installed, remove the faceplate
and black subplate.
2 Using your fingers, gently pull the button forward
(Figure 7).
3 Alternatively, insert a small, flat-head screwdriver from
either the right- or left-hand side of the button and
gently pry it forward.
Figure 7. Keypad Button Removal
After you install or change the button configuration, you
must change the keypad button properties in Composer.
See the Composer Pro User Guide on the dealer portal for
details.
Regulatory/Safety Information
To review regulatory information for your particular Control4
products, see the information located on the Control4
website at: http://www.control4.com/regulatory/.
Warranty
Limited 2-year Warranty. Go to http://www.control4.com/
warranty for details.
About This Document
Part number: 200-00356 Rev. A, 2/15/2013
Split Up/Down
Buttons
Sensor Bar
LED Light Pipe
Actuator Bar
Curved Edge Faces
Top of Keypad