User's Manual

™
Figure 1. Keypad Button Kit
3 Determine the desired button layout. Buttons can be
mixed and matched as desired using the split up/down,
single-, double-, or triple-high buttons in the kit.
4 If you are using the split up/down button assembly,
attach the assembly (Figure 2), and then attach the
sensor bar (Figure 3). These must be placed first in the
bottom position (Figure 4).
Figure 2. Split Up/Down Buttons
Orient the button assembly so that the up button is
on the right, and then slide the mounting holes at the
bottom of the button assembly over the small black
prongs that stick out at the bottom of the keypad
button area.
5 Snap the sensor bar onto the bottom of the button area
of the keypad where the small black prongs protrude
(Figure 3). The sensor bar is the small bar with the clear
lens in the middle.
NOTE: Orient the sensor bar so that the curved edge
faces toward the bottom of the keypad and the
straight edge faces toward the top of the keypad.
Figure 3. Attach Sensor Bar (shown without Split Up/Down
buttons)
Supported Models
• C4-KD120 Keypad Dimmer, 120V
• C4-KD240 Keypad Dimmer, 240V
• C4-KD277 Keypad Dimmer, 277V
• C4-KC120277 Configurable Keypad, 120V/277V
• C4-KC240 Configurable Keypad, 240V
• C4-KCB Configurable Keypad, Bus
Introduction
The Control4® Keypad Buttons let you and your customer
decide how to lay out the buttons on Keypad Dimmers,
Configurable Keypads, or Wired Bus Configurable Keypads
by providing multiple ways to attach the keycaps to
the devices. These buttons come in single, double, or
triple heights as well as a split up/down button. Use any
combination to snap the buttons into place easily.
IMPORTANT! The button configuration defined
for the Keypad or Keypad Dimmer in Control4
Composer Pro must match the physical button
configuration for proper operation.
Keypad Button Installation
To attach the buttons onto a keypad:
1 Remove the keypad button tray and the keypad
buttons from the packaging.
2 Identify all of the pieces in the keypad tray.
Keypad Buttons
Installation Guide
Sensor Bar
Actuator
Bar
Split
Up/Down
Buttons
Triple High
Buttons
Double High
Buttons
Single
High
Buttons
Split Up/Down Buttons
Curved Edge Faces
Bottom of Keypad