User's Manual

™
Figure 3. Dimmer with Actuator Bar
Button Tap Sequences
The button tap sequences are defined in the table below. Button tap sequences
that require a single (1) button should use the top button.
Function Button Sequence
Identify 4
ZigBee Channel 7
Reboot 15
Factory Reset 9-4-9
Leave Mesh and Reset 13-4-13
Troubleshooting
If the light does not turn on:
• Ensure that at least one (1) LED on the face of the dimmer is lit.
• Ensure that the light bulb is not burned out and is screwed in tightly.
• Ensure that the circuit breaker is not turned OFF or tripped.
• Check for proper wiring (see “Sample Wiring Configurations”).
• For help on the installation or operation of this product, email or call the
Control4 Technical Support Center. Please provide your exact model number.
Contact [e-mail] or see the web site www.control4.com.
Care and Cleaning
• Do NOT paint the dimmer or its wall plate.
• Do NOT use any chemical cleaners to clean the dimmer.
• Clean surface of the dimmer with a soft damp cloth as needed.
Regulatory/Safety Information
To review Regulatory information for your particular Control4 products, see
the information located on the Control4 website at: http://www.control4.com/
regulatory/.
Patent Information
Applicable patents are available at http://www.control4.com/legal/patents.
Warranty
For complete warranty information, including details on consumer legal rights as
well as warranty exclusions, review the Warranty card or visit www.control4.com/
warranty.
Figure 6. Multiple Device Location Using Auxiliary Keypad, With Neutral Connection
Figure 7. Multiple Device Location with Auxiliary Keypad, Without Neutral Connection
Figure 8. Multiple Device Location Using Configurable Keypad, Neutral Required
Copyright ©2013 Control4. . All rights reserved. Control4, the Control4 logo, the Control4 iQ logo and the Control4 certified logo are registered trademarks or trademarks of Control4 Corporation in
the United States and/or other countries. All other names and brands may be claimed as the property of their respective owners Pricing and specifications are subject to change without notice
About this Document
Part Number: 200-00306 Rev A, 2/15/2013
Sample Wiring Configurations
Figure 4. Single Device Location, With Neutral Connection
Figure 5. Single Device Location, Without Neutral Connection
Actuator Bar